Lockner, David and Summers, R. and Moore, Diane and Byerlee, J.D. (1982) Laboratory measurements of reservoir rock from the Geysers geothermal field, California. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 19 (2). pp. 65-80. DOI: https://doi.org/10.1016/0148-9062(82)91632-1
Full text not available from this repository.Abstract
Rock samples taken from two outcrops, as well as rare cores from three well bores at the Geysers geothermal field, California, were tested at temperatures and pressures similar to those found in the geothermal field. Both intact and 30?? sawcut cylinders were deformed at confining pressures of 200-1000 bars, pore pressure of 30 bars and temperatures of 150?? and 240??C. Thin-section and X-ray analysis revealed that some borehole samples had undergone extensive alteration and recrystallization. Constant strain rate tests of 10-4 and 10-6 per sec gave a coefficient of friction of 0.68. Due to the highly fractured nature of the rocks taken from the production zone, intact samples were rarely 50% stronger than the frictional strength. This result suggests that the Geysers reservoir can support shear stresses only as large as its frictional shear strength. Velocity of p-waves (6.2 km/sec) was measured on one sample. Acoustic emission and sliding on a sawcut were related to changes in pore pressure. b-values computed from the acoustic emissions generated during fluid injection were typically about 0.55. An unusually high b-value (approximately 1.3) observed during sudden injection of water into the sample may have been related to thermal cracking.
| Item Type: | Article |
|---|---|
| Subjects: | Methodology > Other-additional study Region > USA > California > Geysers Inducing technology > Geothermal energy production Methodology > Method and procesing |
| Project: | SHEER project > THE GEYSERS: geothermal energy production |